2018-19

Permanent URI for this collection

Now showing 1 - 1 of 1

Buck Boost Converter using Sepic Topology
(2019-07-22T10:29:23Z) AKSHAY KUMAR, BIRADAR; AMRUTHA, HEGDE; SHAHID, ANSARI; P TARUN, KUMAR
Nowadays single-ended primary-inductor converter (SEPIC) is used widely for better performance for conversion of voltage Some application of converter only need to buck or boost the voltage and can simply use the corresponding to input sometimes the output are not according to input. Then in that case, it is usually use best to convert that can decrease or increase the voltage Buck-Boost is cheaper but they heat up and having only a capacitor and inductor which causes high amount of input current ripple and this will create high amount of harmonics and its remedy is expensive and thus this makes buck-boost converter very expensive component too. And the major issue with the buck-boost is that they invert the voltage and all these can be eliminated through the Cuk converter but Cuk will create ample amount of electrical stress on components this can result in device failure or overheating .SEPIC will solve above problems easily without any harm to components and also cheap solution to problems and less electrical stress and overheating.